Dangerous-music Additional Switching System Manual de usuario descargar pdf (Pagina 14)

12 | DANGEROUS MUSIC

1. D-Sub to Digital in/out snake:

What:  Connects 4 stereo pairs of digital i/o.

Example: 25-pin D-Sub on one end, eight XLRs on the other (4 female connectors for stereo input and 4

male connectors for stereo out/thru). See photo A for visual conﬁrmation and Appendix for wiring

diagram. This conforms to the Tascam / Digi wiring standard.

Tip:

,Remember, this may be wired for AES or S/PDIF or any combination, without transformers. Keeping

digital cables or a snake on hand to ﬂip the connectors makes this easy (see photo E).

Tip:

,Buy good cable! It’s the superhighway for audio electrons. Go Mogami.

2. AES XLR(F)-XLR(M) Cable:

What:  Connects to an external digital meter and follows current monitor source.

Example: Use 110 ohm shielded cable. (See photo B for visceral conﬁrmation.)

Tip: ,Optionally, connect to an external recorder to create multiple versions for comparative listening.

3. Two XLR(F)-XLR(M) Analog Cables or connect directly XLR(F)-DB25 snake:

What:  Connects the two analog XLR outputs from the DAC-ST to the D-Sub connector on the Monitor

ST. These two outputs from the DAC-ST are joining other device’s outputs, that are meeting at

the D-Sub.

Example: Use shielded cable or depending on positioning (photo C), wire directly with analog XLR(F)-DB25

snake. (See photo D for visceral conﬁrmation.)

[The rear of the Monitor-ST stereo monitor control system pictured above]

[The rear of the DAC-ST in Additional Switching Rack® pictured above]

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 29 30

Sin comentarios

Dangerous-music Additional Switching System Manual de usuario Pagina 14